Mags?

[JaydenBug]

Sry I just got my FS2000 last week and I all ready bought one wrong magazine trying not to do it again so I just wanted to make sure these will work.

AR-15/M16 30-ROUND STEEL MAGAZINE

Mfr:FUSIL USA
All-Steel Construction With Robust One-Piece Body To Handle Extreme Tactical Conditions

Newly designed, 30-round magazine features a strong one-piece steel body built to handle the roughest combat and tactical operations. Precision manufactured to ISO 9001:2000 quality management standards to exceed DoD specs for USGI magazines. Advanced features include a tilt-resistant steel follower and stainless steel spring that ensure even pressure on the round stack for smooth, jam-free feeding. Two-part floorplate with integral lanyard loop removes easily without tools for cleaning and maintenance; floorplate and follower are designed so they can’t be reinstalled the wrong way. Fits minimum-dimension magwells and guaranteed to drop free from mil-spec magwells under its own weight, even when empty. Fits any mag pouch designed to hold standard USGI-spec magazines. Body is precision formed on an 18-stage progressive die system from a single piece of .021" thick 1050 sheet steel and robotically MIG welded for strength and dimensional consistency. Crush resistant to 1,000 lbs. (500 lbs. side load) fully loaded, and impact tested to withstand dropping 1.5m onto a flat concrete surface. Function tested to ensure operation at temperatures from –67°F to +329°F. Body is nitride heat-treated to Rc 60 surface hardness, then pickled to remove the oxide layer before application of the heavy duty manganese phosphate Parkerized finish (MIL-DTL-16232G Type M) for maximum abrasion resistance. After nitride hardening, follower, floorplate, and retainer receive a dry-lube-impregnated powder coating to aid in smooth follower movement. Both finishes resist continuous salt fog exposure for 96 hours without developing corrosion, and also resist bore cleaners, solvents, oils, gasoline, diesel fuel, hydraulic fluid, insect repellents (including DEET), and other harsh chemicals likely to be encountered in a military environment
Pack of 5 $49.99 Clearance


AR-15/M16 30-ROUND STEEL MAGAZINE - Brownells

[akitainu]

They should work fine, but those reviews were a bit iffy. I would suggest either these or these.

Oh, and welcome!

[artranscience]

Akitainu has posted the two mags that everyone suggests here for the FS2K. Both cheap, both work great.

You may want to do some extended reading in this section of the forum - there are a LOT of threads about which mags do and do not work, alongside other important info. It is likely that if you have a question it has already been covered in either FS2000 or FS2000 accessories and mods.

[JaydenBug]

Thanks for the quick response and help.

[Dizzy82]

I have these magazines and I highly recommend them.

AR-15 Magazines

[SgtStrykerUSMC43]

Thanks for the quick response and help.

Brownells, Fusil, BCM - they all work.

[inego montoya]

Sure is nice to be able to buy a top quality mag for just 10 bucks to feed this baby!

Unlike my other FN rifle which shall remain unnamed...

[SONYtec]

Why buy steel mags, when they are heavier than aluminum STANAG mags???

Ditto eveyone's suggstion's.

[Noncentsical]

Durability.

I can step on my SS mags and they still work.
And don't weight significantly more than aluminum IMHO.

[Visceral_Malice]

DH 5.56 30rd Aluminum Mag - Magazines - Accessories

These work well. I just got a couple. If its got a good follower, you're good to go. Check out the countless other magazine threads for the FS2K. There is a lot of good info in them.