FS: 2 NOS PS90 Quad Rail Kits - reduced to $90/ea.

[AvgGunGuy]

FS: 2 NOS PS90 Quad Rail Kits - asking $90 per set or $150 for both.

These parts sets were produced in 2006 and have remained sealed since. They were packaged for use in a MagParts Quad Rail DIY Kit that was never marketed. The package includes every part used to convert the Nitro Airsoft Quad Rail into the MagParts PS90 Quad Rail. With Nitro rails going for less than $40 on auction sites, this would be a great way to get a brand new quad rail at a big discount, while having a little fun in the process.



Includes:

Hard-anodized T6 aluminum PS90 mounting collar
2x hard-anodized T6 aluminum PS90 mounting blocks
Premium grade replacement screws for the entire rail
A MagParts quad rail package insert with installation instructions (replaces the fold card that comes with the nitro rail)

The conversion process takes about 15 minutes to complete. It involves removing the hardware and screws from the nitro rails, and then replacing them with the included hardware. To finish the process, you can trim the two notches off the two side rails to allow easier access to the cocking knobs; but it is not required. (Only a few small metric allen wrenches and some loctite are required.)

PM me if you’re interested. Thanks.

[AvgGunGuy]

Price reduced to $90/ea. or $150 for both sets.