The SFS Got Mail

[jhs27275]

These arrived today and will go on after the custom finish is done.

[Ferris2son]

Sweet. What is the finish you're getting. Did I miss a post?

[jhs27275]

Did I miss a post?

Carry over from this thread.

http://fnforum.net/mag-disconnect-t7102.html

[jyo]

Look like Herrets stocks---I have two sets very much like those---fit on my MK111 is very good, BUT after firing I found I had to releave the wood on the right grip panel where the back of the magazine release extends when dropping the mag---shooting recoil shifted the grips ever so slightly and then the back part of the release would hit the wood and prevent the mag from being ejected---no big thing, a few secouds with a small round wood fine creates the amount of clearence and looks just the same. Of course, this may not be the case with yours---still, I would take it out to the range just to be sure! Good luck.

[jhs27275]

No issues with the wood on these. If you'll take a close look at the right grip you'll see the factory already took care of the problem

[jyo]

Yeah, mine has that same little cut-out on the right panel---still needed more clearence as mentioned---good luck with yours!