FN Herstal Firearms banner

Speedloaders for the FN 5.7

13K views 27 replies 18 participants last post by  Macho1021 
#1 ·
Do you guys know of any sources for a speed loader?
 
#5 ·
tqtran said:
bruced : I hope you are top loading the magazine like an AR15 mag and not like a Glock mag.
As in, place the round on top of the mag and then push down.
Yes to top loading. I find the last 5 rounds or so in a 30 mag to be annoying after reloading for the 10th time in a day.

Thanks for all the responses!
 
#6 ·
bruced said:
I find the last 5 rounds or so in a 30 mag to be annoying after reloading for the 10th time in a day.
It could be worse. You could live in a State where you only had to worry about loading 10 rounds. :-D
 
#7 ·
bruced said:
Yes to top loading. I find the last 5 rounds or so in a 30 mag to be annoying after reloading for the 10th time in a day.
Get more mags to preload before you go to shoot. :)
 
#14 ·
I've always thought the Five-SeveN has some of the easiest loading mags in a pistol.
 
#18 ·
Sounds like a market to make money in.....
 
#21 ·
#22 ·
Ya know a few small steps are usually easier than one big step. If ya got a 20 only load 15, if ya got a 10 only load 8. Not sure on the 20 w/extension to 30, but you get my point. Life is just simpler and easier, particularly when that last cartridge is not quite seated and it "popping out" into your face.
 
#23 ·
With the extension it's a good idea to stop at 27. Easier to load and it also keeps the follower above the joint between the mag/extension and pretty much eliminates any problems from the use of the extension.
 
#25 ·
Popping out in my face. Happened to me yesterday:?:.
Was at Markham Park:target:Range with preloaded mags.

Had four 28 rds, three 20 rds and two factory 10 rds:bullets:.

My last mag to rack was the 10 rd popper:?:.

I always palm spank prior to racking:spank:

Was not sure why this happened other than what was explained above.
Will adjust accordingly.:-o
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top