Magpul Safety Selector

[MOUNT-N-SLOT]

IWC changed out our factory ones for the Magpul versions. Everyone who's handled or used the SCAR like them better.

[HMC499]

Only issue I have with mine is that the selecter itself is sharper and the short right side lever hits my trigger finger once in a while and its just uncomfortable at most. Other than that, I like them way more than FNs levers....

[101ABN327]

Are these a Magpul direct purchase? I don't see them advertised anywhere else... Also, do these work on the SCAR-H?

101

[Rasputin]

Midwayusa has them (where I bought mine). Aimsurplus had them (but was out of stock when I first checked). GT Distributors also had them.

I like them, glad I bought them.

[TJ-6371]

I think I got a bad set as well. I just tried putting them in and they will only go about 2/3 of the way in. It's taking so much force to get a 1/4 turn i'm scared I'll break the screw or my screwdriver.

[Alpha-17]

Look at the selector you're having problems with. Make sure it has the small holes on both sides. If it does, it should work; if it doesn't, email MagPul, and they'll send a replacement.

[TJ-6371]

Thanks for the info, I noticed that last night when I was checking them out. They only have one hole at the top of the switch unlike the originals. I emailed them last night. Thanks again.

[mildot326]

[quote="Alpha-17"]Look at the selector you're having problems with. Make sure it has the small holes on both sides. If it does, it should work; if it doesn't, email MagPul, and they'll send a replacement.[/quote

Are you saying the selector should have a small hole on each selector or each selector should have two small holes on it? Can you post a pic of a GTG selector?

[Alpha-17]

[quote="mildot326"]

Look at the selector you're having problems with. Make sure it has the small holes on both sides. If it does, it should work; if it doesn't, email MagPul, and they'll send a replacement.[/quote

Are you saying the selector should have a small hole on each selector or each selector should have two small holes on it? Can you post a pic of a GTG selector?

I misspoke. What I should have said is that each selector should have a single hole in it that goes through one side completely, and into the other through the gap in the center. The "bad batch" of selectors wasn't drilled properly, and the hole only goes to the center, not into the other side. I hope that makes a little more sense.

[mildot326]

Thanks, I took a look at mine and I have the selectors with just the one hole in each one, it finishes off in the center and doesn't go right through. What now?